¶ Installation of the 1064 Laser Head on the TS2 Model
1.Remove the original Z-axis lifting module and replace it with the lifting module from the kit.
2.Connect the laser cable to the 1064 laser head, and then mount the 1064 laser head onto the lifting module.
3.Connect the Z-axis limit switch and the Z-axis lifting motor wires.
4.Lift the drag chain cover, place the cable inside, remove the old limit plate, and replace it with the new plate provided in the kit.
5.After securing the limit plate, open the mainboard box and plug one end of the extension cable into the motherboard’s TTL port, and the other end into the conversion board.
6.After reattaching the mainboard box, connect the laser cable and the extension cable.
