Installation of auxiliary fan and right sealing plate
Auxiliary Fan Assembly X1
Half round head M3 * 4 X6
Installation of auxiliary fan and external air inlet
External air inlet X1
Self tapping screw ST5 * 12 X2
Half round head M3 * 4 X2
Installation of filter box
Filter box X1
Half round head M3 * 10 X4
Installation of hinges
Hinge X2
Half round head M3 * 10 X4
Installation of magnets, films, and decorative panels
Magnet X3
Right pillar film X1
Note:Before installation, please peel off the protective film on the back adhesive and apply the magnet and PVC film according to the corresponding position. After applying, press tightly to avoid falling off.
Due to the difference in the time of purchase by users, the installation of the right front column profile is slightly different (for details, please refer to the figure below).
As shown in Figure 1, the earlier version of SK1 does not have a recess for the magnet at the right front column profile. We can use the second installation method provided in the link at the lower left corner. You only need to follow the video to directly stick the magnetic strip attached to the cardboard box. If you cannot find it, please contact our official store to obtain it.
Installation Diagram Link
Magnetic strip installation video
Install the top profile of the sealed box
a. First, remove the 8 screws on the top of the machine (as marked in the picture)
Top sealing column X4
Install the top profile of the sealed box
b. Installation of sealed box profiles
Top profile left X1 Top profile right X1
Top profile front X1 Top profile rear X1
Install the top profile of the sealed box
c. Fixed sealing column profile
Half round head M3 * 4 X6
Install the top profile of the sealed box
d. Fixed sealing column front profile
M3 hand screw X2
Installation of left and rear sealing plates
Left sealing plate X1, rear sealing plate X1
Half round head M4 * 8 X8
Installation of right sealing plate
Right sealing plate X1
Half round head M4 * 10 X2
Half round head M4 * 8 X4
Installation of front door handle
T-shaped nylon pad X2
Handle X1
Half round head M3 * 6 X2
Installation of front door
T-shaped nylon pad X4
Front door X1
Half round head M3 * 6 X4
Auxiliary fan and filter box wiring
Remove the bottom sealing screws and foot pads from the chassis
Note: After removing the bottom sealing screws and foot pads, be sure to store them carefully.
Note: The input voltage for both the auxiliary fan and the filter box fan is 24V.
For detailed operational instructions, please refer to the installation video or the kit manual.